8710 / 8711系列电位式位移传感器

用于直接和精确测量机械位移,横向无力驱动,寿命非常长,高位移速度

  • Features

    • 量程范围从 0 … 25 mm 到 0 ... 150 mm
    • 非线性度最高可达 ±0.05 % F.S.
    • 耐用性,使用寿命可达1亿次
    • 可调速度。最高10m/s
    • 驱动无球关节耦合引起的侧向力
    • 可选择集成电缆或插头连接的形式
  • Product data

    型号 8710, 8711
    量程范围
    0...25mm
    0...50mm
    0...75mm
    0...100mm
    0...150mm
    信号输出类型 取决于传感器激励供电电压
    保护等级 IP40
    工作温度 -30°C...+100°C
    激励供电电压 取决于量程范围
    复位弹簧 无,需机构带动复位
    具体特征
    • 量程范围从 0 … 25 mm 到 0 ... 150 mm
    • 非线性度最高可达 ±0.05 % F.S.
    • 耐用性,使用寿命可达1亿次
    • 可调速度。最高10m/s
    • 驱动无球关节耦合引起的侧向力
    • 可选择集成电缆或插头连接的形式
  • Description

    Displacement sensors models 8710 and 8711 with resistance tracks made of conductive plastic material are designed for a direct and accurate measuring of mechanical displacements. A special ball joint coupling is mountable on both ends of the driving rod. Because of this the sensor may be used free of clearance or lateral forces also with angular or parallel misalignment between sensor and measuring device.

    A special multi-fingered slider provides a good electrical contact also at high adjustment speeds or vibrations.

    Areas of application are:

    • Electromagnets
    • Switch and button deflections
    • Pneumatic cylinders
    • Press-fits (longitudinal press-fits)
    • Hydraulic cylinders
    • Measurements of deformation and bending
    • Length tolerances
    • Feeding paths

    Due to the technology employed in potentiometric displacement sensors, they always operate with a sliding contact system. Special processes are applied to give the resistance tracks low friction, low tendency to stick/slip, resistance to abrasion and long-term stability.

    The driving rods are guided in long-life, low-friction sliding bearings with close tolerances; this results in highly precise measurements. Lateral forces reduce the service life and can be avoided by using, for instance, ball joint couplings, included in the burster product range.

    Due to the pump effect, the driving rod has double sliding bearings.

    Mounting

    The sensor is mounted at the left and right longitudinal slot by four mounting angles.

    These slots (W = 2.2 mm, D = 1.6 mm) are closed at the side of the electrical connector.

     

     

  • Downloads

    Data sheet
    pdf 8710/8711参数资料

Related products

Product comparison

    © 2020 波司特精密仪器(上海)有限公司 沪ICP备12015704号沪公网安备31010602000957号